B
A
Seat Adjustments cont.
Seat Slide
To adjust the fore/aft position of the seat, pull the lever located beneath the front
of the seat (A) upwards, thus releasing the slider. Slide the seat to the required
position. Release the lever and rock the seat to ensure the locking mechanism
has engaged.
Seat Reclining
To adjust the angle of the backrest, lift the lever located on the outer edge of the
seat by the pivot point (B). Tilt the backrest to the required angle. Release the
lever and ensure that the locking mechanism has engaged.
Lumbar Support
To adjust the lumbar support in the backrest use the pump located on the inner
side of the seat to inflate the support. To reduce the lumber support given, press
the button on the end of the pump to deflate the support.
2.23 Seat Belts
When fastening your seat belt please ensure that it isn’t obstructed in any way
before clicking in the catch. Please ensure that the catch clicks in correctly.
When releasing the belt press the red button on the catch, the belt may need to be
guided back to assist the reel, make sure the belt is fully retracted before leaving
the vehicle. Clean the seat belt webbing using soapy water.
WARNING: Use only soapy water and not solvents or abrasives to clean
the webbing.
TVR seat belts are intentionally set to lock easier than those of conventional
road cars in order to mime the action of racing harnesses. However, this can
mean that it can be difficult to pull the belt out when the car is parked nose
down or on a lateral slope.
Instrumentation
2.21 Interior light
The interior light is located in the centre of the rear header rail.
Position 1.
Light will remain permanently off.
Position 2.
Light will come on when drivers or passenger
door is open. After closing the doors the light will
remain lit for approx. 15 seconds or until the
windows have closed.
Position 3.
Light will remain permanently on.
Please note: Activating the ignition will cancel the interior light. On
disarming the alarm (with your key fob) the interior light will illuminate
for 20 seconds. Switching on the ignition will cancel the light. The interior
lights work independently from the ignition.
2.22 Seat Adjustments
Instrumentation
1
2
3
23
24