2.0
Operational instructions
5
The following
MUST
be read before attempting to use the NFM3:
1 The NFM3 is designed for use on Inert Arc Welding Shielding
and Back Purging gases only.
2
Always ensure that the wire feed drive wheels are slackened
off so that welding wire cannot be fed through the NFM3.
3
When using on equipment with High Frequency Arc
Starting, always ensure that the HF is turned off.
2.1
Operational warnings
2.2
Powering up the unit
Switch the On/Off switch to the ‘On’ position.
The LCD will illuminate and the software version number together with the
model type will be displayed for a few seconds the screen will then revert
to the standard display layout.
NFM3 Standard:
Start Up screen
NFM3 Standard:
Main screen
