8
1T-CT-632 receiver
’s input and attach it to the Cat.6 input socket on the 1T-CT-633
Repeater.
Attach a new Cat.6 cable to the Cat.6 output of the 1T-CT-633 unit and plug the remote
end of the new cable into the 1T-CT-
632’s Cat.6 input connector.
(If you wish, you can use the 1T-CT-633 Repeater as a Transmitter. In that case, switch
the HDMI/Cat.6 switch to the HDMI position and connect the HDMI source to the 1T-
CT-633 via the HDMI input socket.)
Connect the supplied AC adapters first to the Transmitter, Repeater and Receiver and
then to the AC sockets.
Lastly, turn on the source device and remote display. The source signal should now
appear on the remotely located display. If not, consult the Troubleshooting section of
this manual.
If you are placing a Cat.6 system into initial operation with a repeater included, consult
the maximum allowable cable length table below.
Product ID
Max HDMI In Max HDMI Out
Max Cat.6
1T-CT-631A
1T-CT-632
System
10M (33
’)
10M (33
’)
1080p (12 bit): 15M (49’)
1080p (8 bit)
: 38M (125’)
720p/1080i: 50M (165
’)
480p: 60M (195
’)
Product ID
Max HDMI In Max HDMI Out
Max Cat.6 In
Max Cat.6 Out
1T-CT-633
10M (33
’)
X
1080p:
38M(125’)
480p: 60M(195
’)
1080p:38M(125
’)
480p: 60M(195
’)
5.0
OPERATING THE 1T-CT-631A / 1T-CT-632 / 1T-CT-633 SYSTEM
5.1
Operating the Transmitter/Receiver link
Once the connections have been made and power applied, Check to see if there is a
picture on the display device at the receiver end and that audio is being received. If the
display and audio are working, there are no additional operational adjustments required.
If there is no picture, or if the audio is either missing or has a problem, place the
TV/STD switch on the 1T-CT-631A in the STD position and then try moving the adjacent
8 Bit/10Bit/12Bit switch to each of its three positions while you recheck for a picture and
correct audio on the remotely located display device.
Note: For either initial power up or after you change the TV/STD switch setting, it is
recommended that the power on sequence be as follows: HDMI to Cat.6 Transmitter,
HDMI to Cat.6 Receiver, HDMI source and HDMI destination device
– in that order.