Troubleshooting
Page 19 of 20
RED LED
Audio Remote Control V2 (20)
①.
Disconnect all mains electric power to the bed, for at least 60 seconds.
②.
Press UP or DOWN Button on TV Lift Remote Control (19) and keep holding button down,
simultaneously re-connect mains electric power to bed keeping button down for at least a further
5 seconds. TV Lift unit receives signal from Remote Control and lift will begin to move UP or
DOWN whichever direction was chosen.
③.
Re-connection is now completed.
If your equipment does not operate please check all the power connections from wall to the socket in the footboard.
Make sure TV is switched on. (Note: TV will only work when it is in the up position).
If you cannot resolve an issue or still have a problem or need help, please contact your Retailer for advice.
Occasionally you may find the radio wave connection between remote control and TV Lift is lost, probably due to
atmospheric conditions. In that case please follow these simple instructions:
STOP
UP
DOWN
19
TV Lift
Annecy & Lyon Audio System
Occasionally you may find the radio wave connection between Remote Control and Audio
System is lost, probably due to atmospheric conditions.
In that case please follow these simple instructions:
1.
Make certain batteries are in good condition and fitted correctly.
2.
Press VOL+ & VOL- at exactly the same time keeping both pressed down until the RED LED
flashes 3 times.
3.
Re-pairing is now complete and the audio system and remote control is now a unique set, it
cannot be used with another audio system, in another bed.
4.
Note, if two beds were purchased for same home, make sure power is only connected to the
bed being re-paired.
5.
When finished with first bed and all is working satisfactorily, turn power on to the second bed.
O
