Reset button
• Join network. Press the reset button and release to view the device
status on the network. When the device is in the network, the green
light flashes three times; When not in the net, the red light flash three
times.
• Reset. Press and hold the device reset button for five seconds until
the device blinks green at a short time and enters the networking
mode for one minute. After the networking succeeds, the device
indicator turns off.
Anti-tamper button
When the rear cover of the device is installed, the anti-disassembly
button is pressed, and it belongs to the normal state. When the rear
cover of the device is removed, the anti-disassembly button is not
pressed, and the anti-disassembly alarm is triggered.
LED status
What it means
Green LED keeps flashing
rapidly
Device is ready to join a ZigBee
network
Green LED from flashing to
off
Joined a ZigBee network or network
timeout
Red LED flashes once
Motion detected
Red LED flashed twice
Knock-down detected
LED indicator
The LED status gives the following information:
Reset button
Anti-tamper button