Tuttnauer AMS10-120-T, Operation And Maintenance Manual

Page: 83 / 104

11. TSC Printer Installation (optional)
The following is a user's set up guide that explains describe:
l
General printer information.
l
Safety instructions
l
How to install TSC printer and connect it to the T- Edge autoclave for the
first time. (Shall be performed by qualified personnel).
l
How to set, operate, use and maintain the printer after the first installation.
11.1 General printer information
The printer(s) are optional and can be purchased/ordered from Tuttnauer by
the customer, the printers can easily be installed and connected to the
autoclave following the instructions below.
The options includes:
l
One printer connected to the autoclave, and can be loaded with thermal
paper roll, or with label roll. The user can direct the printer to switch
between printing on thermal paper roll or label roll.
l
Two printers connected to the autoclave, one loaded with thermal paper
roll, and the second printer is loaded with label roll.
11.1.1 Printer Output:
The autoclave is equipped with a character printer, which prints a detailed
history of each cycle performed. (This can be used for the record or for
subsequent consideration.)
The printing is on thermal paper with a defined set of characters per line and
contains important information such as some of the main following details:
n
Date:, Time: , Ser. Num:, Model:, Version:,
n
Cycle Num:, Cycle Name:, Ster Temp:, Ster Time:, Dry
Time:,End Temperature
When the sterilization cycle begins the printer starts printing the above data.
After the preliminary printing, the autoclave starts performing the sequence of
operations of the cycle. The measured values of temperature and pressure are
printed at time intervals, according to the phase of the process, as shown in
the table on the next page.
Page 76