Tuthill 6000, Installation And Service Instructions Manual, Page: 21 / 36

Service Manual # 67
Page 21 of 36
14. Once the pump/inner magnet sub-assembly is in place, fasten it to the adapter with screws
from the cover end.
15. Place pump/inner magnet sub-assembly on a flat surface with the bearing housing register end
facing upward.
16. Place key into bearing housing shaft keyway.
17. Place bearing housing sub-assembly on a flat surface with shaft facing upward.
18. Carefully lower outer magnet onto shaft until outer magnet bottoms onto shaft shoulder.
19. Lock outer magnet onto shaft with set screws, installing the cone-pointed set screw first.
! CAUTION
DO NOT PLACE HAND OR FINGERS BETWEEN THE BRACKET AND ADAPTER. The magnets
are extremely strong and will attract all metallic objects and can be the source of pinch points. Do
not wear watches or other metallic jewelry when working with magnets. See warning on page 2.
Use jack screws to assemble models 6200 Series pumps. Jack screw kits are available as part
number 2CMG 558 for models 6202, 6203 and 6204 and part number 5CMG 558 for models 6205
and 6206.
Failure to follow proper procedures or use appropriate tools could result in injury to you or damage
to either personal property or the pump.
17. Install outer magnet assembly. Use jack screws to control the attraction of the inner and outer
magnets:
a. Place (3) guide studs into adapter through the bracket screw clearance holes and hand-
tighten.
b. Screw (1) jack screw into bearing housing until it extends to the end of the outer magnet.
c. Slowly unscrew jack screw from bearing housing. This will lower sub-assembly into
adapter register.
d. After magnet bearing housing sub-assembly has been lowered into place, remove guide
studs and jack screw.
18. Secure bearing housing sub-assembly into place with screws.
19. Proceed to couple completely assembled unit to drive.