15
English
OK
OK
8.1.1 Hold for 3 seconds for Vehicle Selection. The display as shown below will list “CAR 1”
to “CAR 3”.
8.1.2 Press , then “CAR 1” will blink. Press to select the vehicle you would setup,
then press to confirm, the receiver display will go to the TPMS setting mode and a short
beep will sound after a moment.
8.1.3 Please establish the TPMS parameter settings for this vehicle, starting with section 8.2. When
“CAR 1” settings are complete, go back to Vehicle Selection to repeat the setting procedure
for “CAR 2” and “CAR 3”.
8.1.4 If the user has two or three vehicle parameters already saved in the receiver, the receiver will
automatically connect with the closest paired vehicle, identify the sensor IDs for that vehicle,
and display the correct parameters in several minutes.
If there is a delay after changing the vehicle on the receiver, reset the receiver power in order
to get the corresponding vehicle TPMS data sooner.
CAR
CAR
CAR
1
2
3
Note:
User will have 60 seconds to make any changes, if no change is made within that period, the
receiver will beep for a long tone to warn that the settings have not been completed, and
display will return to Driving Mode.
