Page 2 of 3
TS300A Rev B
3.
Assemble cylinder cover
Slide cylinder (A) up through cylinder (B)
(see fig 1). With cylinder (A) engaged with
cylinder (B), slide cylinder (C) down over
cylinders (A and B) (see fig 2). Refer to
fig. 3 for completed assembly.
4.
Push the cylinder covered with the
telescopic sleeve into the base.
5.
Attach seat to cylinder. Line
up hole over cylinder, and place
seat down. By grabbing the seat,
firmly push the entire chair towards
the floor to properly lock the taper
on the cylinder into the seat and
the base. Fig. 1 Fig. 2
6.
Remove the knob from the control (Fig. 1). Push bottom
end of the upright into the channel at the back of the control
plate (Fig. 2) and tighten the seat hand wheel knob, as
shown (Fig. 3).
fig. 1
fig. 2
fig. 3
A
B
A
B
C
A
B
C
A
B
C
