20
© TrynEx International 2014 F51507A REV-A141701
Assembly Instructions
A: Slip Outer Axle Bearing onto one end of the axle and secured inside the Axle Frame (there is a slot that needs matched with the frame).
Slide the Inner Axle Bushing on the axle and into placing, fitting snuggly inside the Inner Axle Bushing. Repeat this for both sides.
B: Attach Wheel to the right side of the axle by inserting a M6 x 60 bolt through both the wheel hub and axle. Fasten with lock nut M5.
Refer to the diagram below to ensure this wheel, the drive wheel, is in the correct location.
C: Attach wheel to the left side of the axle. Secure with a washer and push nut.
D: Install a Push Nut at the other end of the axle.
STEP 5: ATTACH THE WHEELS
Attach the handle shaft to Lower Frame Assembly and fix the pivot & bracket assembly on the Lower Frame Assembly by using two sets of
hex bolt M6x55 and lock nut M6. The Bracket should be to the operator’s right.
STEP 6: INSTALLING HANDLE SHAFT
Summary of Contents for ts25
