Lit. No. 76736, Rev. 00
10
July 1, 2020
5. Tighten the 1/4" hex nuts against the pivot bracket
to prevent change in calibration.
6. Adjust the tension on the
fl
ow control lever by
tightening or loosening the tension nut as shown.
7.
USING HAND TOOLS ONLY,
tighten all fasteners
on the spreader frame.
8. Insert the agitator to the pinion shaft on the inside
of the hopper.
NOTE: Make note of the position of the
fl
at side of
the agitator. The pin should be installed as shown.
9. Install the debris screen into the hopper. Insert
the pre-installed 1/4" x 1" stainless steel cap
screws through the holes in the side wall of the
hopper. Secure with 1/4" stainless steel locknuts.
TIGHTEN WITH HAND TOOLS ONLY.
3. Insert
the
fl
attened end of the control rod into the
lever on the gauge as shown. Turn it to lock in
place. Push the lever forward to setting "0." Align
the control rod with the hole in the pivot bracket.
Pull the lever backward to insert the control rod
through the hole in the pivot bracket. Install a
1/4" hex nut on the control rod.
4. Pull the lever back to setting "30" as shown. Push
the pivot bracket forward so that the shut-o
ff
plate
in the hopper is in the full open position.
NOTE: Setting 30 on the
fl
ow control
lever must place the shut-o
ff
plate in the
"FULL OPEN" position to be properly calibrated.
ASSEMBLY
1/4"
Hex Nuts
Pivot
Bracket
Control
Rod
Pivot
Rod
30
Control Rod
Tabbed Hole
Control Rod
Lever
Tension Nut
Gauge
Flow
Control
Lever
Summary of Contents for TS-50
Page 2: ......
