Aerator
PRO-26
10
OPERATION
Operation
TO AVOID SERIOUS INJURY,
Read and Understand the Entire
Operator’s Manual Before Operating This
Machine.
PRE-OPERATION CHECK LIST
Safety First
Wear the appropriate safety gear.
Hearing protection, gloves and
safety shoes are recommended when
operating the Aerator.
Check – The oil level in the engine crankcase
with the engine horizontal. If necessary, fill the
engine crankcase in accordance with the engine
manufacturer’s instructions. Engine is shipped from
the factory without oil.
Check – The oil level in the engine gear reducer
with the engine horizontal. Fill in accordance with
the engine manufacturer’s instructions. Engine gear
reducer is shipped from the factory without oil.
Grease – The fittings in the wheel hubs.
Use fresh fuel of a type and grade recommended by
the engine manufacturer. Fill the tank 3/4 full.
Inspect – The tines and the V-belt for damage.
Check – All guards are in place.
Check – Retighten any loose nuts and screws to
ensure safe operation.
Check – Front drum is completely filled with water.
Check – The work site for above and below ground
obstructions and/or dangerous areas.
MOVING THE AERATOR TO THE WORKSITE
When moving the aerator in a vehicle or on a trailer, the
machine must be securely tied down. Relying solely on
the aerator drive train to prevent movement may cause
damage to the tines, drive mechanism, and transport
wheels mechanism. Use wheel chocks and chains to
secure the aerator to the vehicle or trailer. Place a piece
of plywood under the tines while it is being moved to
provide extra protection for the aerator tines and the
vehicle or trailer.
When Being Moved By Vehicle Or Trailer,
Securely Tie Down The Aerator To Avoid Damage
To The Tines, Front Tires and Transport Wheels
Mechanism.
Do not tip the Aerator on its back or nose during
transportation, service or cleaning. If tipped, engine oil
from the crankcase will enter the piston cylinder and
foul the spark plug.
When loading or unloading the Aerator, do not attempt
to drive up or down truck or trailer ramps. Stop the
engine and manually push the aerator on any ramps.
The PRO-26 Weighs 175 Kg (385 Lbs).
TO AVOID SERIOUS INJURY,
Use Proper Rated Lifting Equipment and
Techniques and To Lift the Aerator.
WORK SITE PREPARATION
Under certain conditions, the Aerator tines can reach
a depth of 115 mm (4-1/2” inches). Damage will occur
to any buried object that the tines may come in contact
with. Plan your path and know the location of any below
ground as well as above ground objects that could be
damaged by the aerating process.
Locate and mark
all shallow buried electric service,
cable TV, telephone, outdoor lighting, and any other
buried cable that may be damaged by the aerating
process.
Locate and mark
all irrigation heads, above and below
ground irrigation control boxes, and any shallow
buried irrigation lines that may be damaged by the
aerating process.
Locate and mark
any shallow buried natural gas,
propane gas, or other gas or fuel line that may be
damaged by the aerating process.
Locate and mark
any shallow buried roof drain pipes,
drain tiling, drain catch basins, or any other buried
drainage items that may be damaged in the aerating
process.
FILLING FRONT WATER DRUM
(See Figure 3)
The front drum should be filled with water before
operation. The weight of the water helps the tines
reach the proper depth as well as aiding in traction and
stability.
● Rotate the front drum until the fill plug is at the top.
● Remove the plug and fill the front drum with water.
The front drum must be completely filled with water. A
partially filled drum will cause the machine to wander as
the weight of the water shifts from side to side.
WARNING
SAFE-008
SAFE-06
WARNING
WARNING
CAUTION
