FUNCTION
Press Mode key (
○
○
○
○
4 ) for scrolling more display function as follows.
Here will show the emissivity data. (The default emissivity is 0.95.)
Press Mode key (
○
4 ) , then press Up key (
○
2 ) or Down key (
○
3 ) to
set the
emissivity
, then press Mode key (
○
4 ) to confirm it. The emissivity can be
changed from 0.10 (10E) to 1 (100E).
Press Mode key (
○
4 ) for the
Maximum (MAX), Minimum (MIN), Different
between MAX and MIN (DIF) and Average (AVG) modes. During the
measurement, the special modes reading will be displayed beside the
mode icon.
Press Up key (
○
2 ) or Down key (
○
3 ) key to change the
High Alarm (HAL)
or
Lo Alarm (LAL)
, then press Meas. key (
○
6 ) to confirm it. For example: When
the reading 26.9
o
C < LAL 27
o
C, the Low icon will flash and you will hear a
beep sound.
Connect the thermocouple with Thermocouple socket (
○
5 ) and put the probe
in/on the target, the thermometer will display the temperature automatically
without pressing any button. To see the minimum or maximum data during
the probe measurement, please hold down the Up key (
○
2 ) or Down key (
○
3 ).
After measure high temp, the probe may remain HOT for a while.
** The thermometer will automatically shut off if left idle for more than 60sec, unless in
PRB mode. (In PRB mode, it will shut off if left idle for more than 12 minutes.)
ADD VALUE
In E,MAX, MIN,
DIF, AVG mode:
Press Up key (
○
2 ) for
LOCK mode
ON/OFF.
The lock mode is
particularly useful for continuous monitoring of temperatures for up to
60 minutes.
Press Down key (
○
3 ) for
o
C
or
o
F transferred.
In all modes:
First hold on the
Meas. key (
○
○
○
○
6 )
and press Up key (
○
2 ) for
backlight
function
ON/OFF.
and press Down key (
○
3 ) for
laser
function
ON/OFF.
STORAGE & CLEANING The thermometer should be stored at room temperature between –20 to +65
o
C (-4~149°F).
The sensor lens is the most delicate part of the thermometer. The lens should be kept clean at all times, care should be taken when cleaning
the lens using only a soft cloth or cotton swab with water or medical alcohol. Allowing the lens to fully dry before using the thermometer. Do not
submerge any part of the thermometer.