Turf Equipment Z-SPRAY JUNIOR Series, Operator'S Manual

Page: 16 / 64

Operation
put the choke in the “OFF” position. Do Not run a
warm engine with the choke in the “ON” position.
g315169
Figure 5
1. LH Motion control lever 5. Ignition switch
2. Front reference/Speed
control bar 6. Hour Meter
3. Throttle 7. RH Motion control lever
4. Choke
Throttle Control
Located in the center of the control console (see
Figure 5).
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
Ignition Switch
Located on the right side of the control console.
The ignition switch is used to start and stop the
engine. The switch has three positions “OFF”, “ON”
and “START”. Insert key into switch and rotate
clockwise to the “ON” position. Rotate clockwise to
the next position to engage the starter (key must be
held against spring pressure in this position). Allow
the key to return to the “ON” position immediately
after the engine starts.
Hour Meter
Located to the right of the throttle.
The hour meter is connected to a charge circuit
installed in the engine block and it records the
number of hours that the engine has run. If ignition
switch is left on without engine running, hour meter
will not run.
Spread Impeller Speed Control
Located on the left side of the control console (see
Figure 6).
Rotate the knob counterclockwise to start the
impeller and to increase the speed and pattern width.
Rotate the knob clockwise to decrease speed, pattern
width, and to turn the impeller off.
16