Maintenance
g310417
Figure 26
1.
Nut
3.
Motion control linkage
2.
Rod end
•
If the control levers do not contact the
reference bar, then proceed to step4.
4.
Allow the control levers to return to neutral.
Remove the quick attach rod end on the bottom
of the motion control linkage. Rotate the
turnbuckle clockwise (as viewed from the top of
the machine). Reinstall the rod end and move the
control lever forward. Repeat this step until there
is minimal gap or contact between the control
lever and the front reference bar.
5.
Remove the rod end quick attach, rotate the rod
end clockwise one more full turn.
6.
Reinstall the rod end.
7.
Repeat steps 3 through 6 for other motion control
linkage.
Cleaning
Clean Engine and Exhaust
System Area
Service Interval: Before each use or daily
(May be required more
often in dry or dirty
conditions.)
CAUTION
Excessive debris around engine cooling air
intake and exhaust system area can cause engine,
exhaust area, and hydraulic system to overheat
which can create a fire hazard.
Clean all debris from engine and exhaust system
area.
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Clean all debris from rotating engine air intake
screen, around engine shrouding, and exhaust
system area.
3.
Wipe up any excessive grease or oil around the
engine and exhaust system area.
Remove Engine Shrouds and
Clean Cooling Fins
Service Interval: Every 80 hours
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Remove cooling shrouds from engine and clean
cooling fins. Also clean dust, dirt, and oil from
external surfaces of engine which can cause
improper cooling.
3.
Make sure cooling shrouds are properly reinstalled.
Operating the engine without cooling shrouds will
cause engine damage due to overheating.
Clean Debris From Machine
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Clean off any oil, debris, or grass build-up on the
machine and aerator deck, especially under chain
41