turck TN-UHF AUS-CDS Series, Instructions For Use Manual

Page: 158 / 225

Setting
RFID channels – overview of the commands
158
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
8.5 RFID channels – overview of the commands
RFID commands are initiated via the command code in the process output data of an RFID
channel. The commands can be executed with or without a loop counter function. The loop
counter must be set individually for each new command.
NOTE
After commands are executed without the loop counter function, the device must
be reset to the Idle state before a new command is sent.
„ After a command is executed, send an idle command to the device.
Command Command code Possible for
hex. dec. UHF
compact UHF
extended
Idle 0x0000 0 x x
Inventory 0x0001 1 x x
Fast inventory 0x2001 8193 x x
Read 0x0002 2 x x
Fast read 0x2002 8194 x x
Write 0x0004 4 x x
Fast write 0x2004 8196 x x
Write and verify 0x0008 8 x x
Continuous mode 0x0010 16 – x
Get data from buffer
(Continuous mode) 0x0011 17 Max.
128 bytes x
Get data from buffer with fast
command processing
(Continuous mode) 0x2011 8209 Max.
128 bytes x
Continuous presence sensing mode 0x0020 32 – x
End Continuous
(presence sensing) mode 0x0012 18 – x
Read/write head identification 0x0041 65 x x
Direct read/write head command 0x0060 96 x x
Direct read/write head command
with fast command processing 0x2060 8288 x x
Set tag password 0x0102 258 x x
Set tag password with fast command
processing 0x2102 8450 x x
Set read/write head password 0x0100 256 x x
Reset read/write head password 0x0101 257 x x
Set tag protection 0x0103 259 x x
Set tag protection with
fast command processing 0x2103 8451 x x
Set permanent lock (Lock) 0x0105 261 x x
Set permanent lock with fast
command processing 0x2105 8453 x x
Tag info 0x0050 80 x x