Connection to a Siemens Step 7 - usage of the TURCK- example program
D301171 - IO-Link master 1108
4-2
Introduction
This chapter describes the connection of the IO-Link master SDPX-IOL4-0001 to a Siemens
PLC S7 (C1-master), the parameterization of the IO-Link master and the connected IO-Link
devices per GSD as well as a description of the IO-Link function block "IO-Link CALL" for the
S7.
The access to the IO-Link master via Ethernet-PROFIBUS-interface PB-XEPI (C2-master incl.
communication-DTM) and TURCK-DTM is described in the following chapter,
.
All manufacturers of control systems offer plug-in network cards for their PLCs, to which the
SDPX-IOL4-0001 can easily be connected. Furthermore, it is possible to use a PC as a master
if it has an appropriate PC PROFIBUS card.
Please refer to the respective manuals supplied by manufacturers for detailed information
concerning individual control systems and automation devices.
The designations used in this manual for programmable logic controllers and software
programs are registered and protected trademarks belonging to the respective manufacturer.
Note
The SDPX-IOL4-0001 can only be used as PROFIBUS-DP-Slave. The module has
no DP-master function.
Attention
The network and PC cards must comply with standards defined in PROFIBUS-DP
DIN 19 245 Part 3.