15
[email protected] • www.turck.com • 2015/02
Mounting
Type name
Description
Image
RKC4.5-5T-2/TEL
Female connector, straight, with
2 m PVC cable, open end
L
RKC4.5-5T-5/TEL
Female connector, straight, with
5 m PVC cable, open end
RKC4.5-5T-10/TEL
Female connector, straight, with
10 m PVC cable, open end
WKC4.5-5T-2/TEL
Female connector, angled, with
2 m PVC cable, open end
26,5
M12 x 1
ø 15
32
L
WKC4.5-5T-5/TEL
Female connector, angled, with
5 m PVC cable, open end
WKC4.5-5T-10/TEL
Female connector, angled, with
10 m PVC cable, open end
MW-18
Mounting bracket, stainless
steel, for M18
MW-30
Mounting bracket, stainless
steel, for M30
In addition to the above-mentioned connection cables,TURCK also offers other cable types for specific applica-
tions with the correct terminals for the “High-End” ultrasonic sensor. More information on this is available from the
TURCK product database at
in the Connectivity area.
5
Mounting
The sensors can be mounted in any position (orientation).
The maximum tightening torque for fastening the sensors is 20 Nm.
➤
➤
Clean the mounting surface and the surrounding area.
➤
➤
Install the sensor in the fixture (mounting bracket or fixing clip), if used.
➤
➤
Install the sensor or the mounting fixture at the intended location.
Make sure that the connector on the rear of the sensor remains accessible.
Mount the sensor so that the blind zone is clear of any relevant objects.
Refer to the following wave patterns or the section “Technical Data” for the blind zone:
Ultr
asonic sensors
“H
igh End“
