4
www.turck.com
• 1-800-544-7769 • Fax:
(763)
553-0708 • TURCK • Minneapolis,
MN
55441
www.turck.com
• 1-800-544-7769
• Fax: (763) 553-0708
• TURCK • Minneapolis, MN 55441
5
7. Double -click on node A. Or right-click on node A
and select properties.
8. Input and output data size is defined by position of
Transfer Size switch, Figure 1. If Transfer Size switch is
set to programmable selection (position 5), you need
to edit and change Produced Data Size and Consumed
Data Size parameters according to next figure. The same
procedure is done twice, for Channel A and Channel
B. Remember that you need to reset or cycle power
of the device to make changes permanent. Also, if
user defined:
• Input data size of node A = Output data size of node B
• Output data size of node A = Input data size of node B
9. Write down Produced (Input or Rx) and Consumed
(Output or Tx) data size. These values are entered
during mapping the device into Scanners I/O map.