background image

Regulatory Information 

Caution: Only use TURBONET approved accessories. 

 

Battery Safety 

1.

 

The area in which the units are charged should be clear of debris and combustible materials or 

chemicals. Particular care should be taken where the device is charged in a non -commercial 

environment. 

2.

 

Follow battery usage, storage, and charging guidelines found in the user guide. 

3.

 

Improper battery use may result in a fire, explosion, or other hazard. 

4.

 

To charge the device battery, the battery and charger temperature must be between 0

°

C~+45

°

C. 

5.

 

Do not use incompatible batteries and chargers. Use of an incompatible battery or charger may present 

a risk of fire, explosion, leakage, or the hazard. 

6.

 

Do not disassemble or open, crush, bend or deform, puncture, or shred. 

7.

 

Severe impact from dropping any battery-operated device on a hard surface could cause the battery to 

overheat. 

8.

 

Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals. 

9.

 

Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose 

to water or other liquids, or expose to fire, explosion, or other hazard. 

10.

 

Do not leave or store the equipment in or near areas that might get very hot, such as in a parked 

vehicle or near a radiator or other heat source. Do not place battery into a microwave oven or dryer. 

11.

 

Battery usage by children should be supervised. 

12.

 

Please follow local regulations to promptly dispose of used re-chargeable batteries. 

13.

 

Do not dispose of batteries in fire. 

14.

 

Seek medical advice immediately if a battery has been swallowed. In the event of a battery leak, do not 

allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected 

area with large amounts of water and seek medical advice. 

 

 

Federal Communication Commission Interference Statement 

 

This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the  following  two 

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation. 

 

This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital  device, 

pursuant to Part 15 of the FCC Rules.    These limits are designed to provide reasonable protection 

against  harmful  interference  in  a  residential  installation.  This  equipment  generates,  uses  and  can 

radiate  radio  frequency energy  and,  if  not  installed  and  used  in  accordance  with  the  instructions, 

may  cause  harmful  interference  to  radio  communications.    However,  there  is  no  guarantee  that 
interference  will  not  occur  in  a  particular  installation.    If  this  equipment  does  cause  harmful 

interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one of the following measures: 

Summary of Contents for TurboMate E2









Reviews: