Turbolock TL111, Manual

Page: 17 / 36

7 U R RFN 7 352
3DUW &U DWL D RUWL , WDOOL WK 6WULN
6W S
3XVK WKH GRRU XQWLO QHDUO FORVHG DQG FKHFN ZKHUH WKH ODWFK V EROW WRXFKHV WKH IUDPH
6W S 8VH D SHQFLO WR PDUN WKH KRUL RQWDO FHQWHU RI WKH ODWFK RQ WKH GRRU IUDPH
(Fig. 15)
6W S
Open the door again and extend the line over the edge of the door and inside the frame.
6W S 0HDVXUH WKH LQVLGH RI WKH IUDPH HWHUPLQH DQG PDUN WKH KDOIZD SRLQW URP WKLV SRLQW
use a ruler to draw a line straight down so that it intersects the existing line.
(Fig. 16)
6W S
Use a 7/8” (22.2mm) spade bit and a drill to make two partially overlapping holes about
0.6” (15mm) deep centered both above and below the center line. If needed, use the
chisel to make the hollow (aka “mortise”) more square. If you choose to use the strike
box, you may need to chisel slightly deeper.
(Fig. 17)
If using a spade bit, do not drill at high speeds as this may tear out extra wood and/or damage
WKH GRRU RU GRRUIUDPH
6W S ROG WKH VWULNH SODWH RYHU WKH PRUWLVH 8VLQ D SHQFLO PDUN D OLQH DURXQG WKH HG HV RI
SODWH WR XVH DV D XLGH IWHU PDUNLQ DW WKH VWUDL KW HG HV RI WKH SODWH UHPRYH WKH SODWH
6W S Chisel about 1.5mm deep or until strike plate sits ush with door frame. If you choose to
use the strike box, you may need to chisel slightly deeper.
During chiseling, it’s highly recommended to stop and check to see if the strike plate sits ush
in the doorframe over the strike box. If not, chisel a little more and check again. Be careful not
WR FKLVHO WRR GHHS RWKHUZLVH WKH ORFN PD QRW IXQFWLRQ FRUUHFWO DIWHU LQVWDOODWLRQ
2
3/4
” 2
3/8
”
(Fig. 15)
(Fig. 16)
(Fig. 17)