Appendix 1 - Oven Door Reversal
17
18. Remove Blanking Screw and Door Catch from front of
oven
and swap around (refer ‘Adjusting Door Catch’).
19. Fit door spacers removed at Item 13 previously, to
lower hinge pivot bolt.
Oven Door Re-Fitting
Fit the Door.
1. Refit oven door by locating
bottom of door onto bottom
hinge plate pivot bolt and
spacers.
2. Fit top of door into top
hinge plate and secure with
top pivot bolt.
Fit Inner Glass to Door.
NOTE: It is important to ensure that the inner glass
is fitted correctly and that the glass pivots at
the hinge end of the door and not the handle
end.
3. Fit pivot spacer removed at Item 3 on previous page,
to the lower inner glass pivot and locate inner glass
lower pivot into position on inside of door.
4. Locate top pivot of inner glass
into top of door and secure in
position
with inner glass
retaining clip.
5. Lift inner glass up onto locking
catch to lock glass into
position.
Top Door Pivot Bolt.
Inner Glass Locking Catch
Screw and
Retaining Clip.
Adjust Door for Correct Alignment.
Check alignment and operation of the door. Ensure that
the door is correctly aligned horizontally and vertically.
1. To align, slacken off the
upper and lower hinge plates
and correctly align the door.
Re-tighten both hinge plates.
2. Check that the roller catch
correctly retains door in the
closed position.
3. To adjust, slightly loosen
screws securing roller catch
and close the door. The
roller catch will centralise
itself.
4. Open door and tighten roller
catch securing screws.
Adjusting Door Catch
If the door sealing requires adjustment, carry out the
following to adjust:-
1. Check that the door seals
correctly when closed, by
placing a sheet of paper
between the door and the
seal.
2. Close the door on the paper
and attempt to withdraw the
paper by firmly tugging on
the paper. The paper should
just pull out with some
resistance but without tearing.
3. To adjust the door catch, loosen the locking nut on
the door catch:-
a. If the paper withdraws easily,
screw the door
catch
‘In’
by ½ a turn
and repeat the test above
until adjusted correctly.
b. If the paper cannot be withdrawn and the door
springs open,
screw the door catch
‘Out’
by ½ a
turn
and repeat the test above until adjusted
correctly.
4. Tighten the locking nut on the door catch.
Slacken these screws to adjust
door vertically - horizontally.
Blanking Screw
Door Catch
Locking Nut
