5
Installation (Vent outside)
Attention! Observe the warning in the instruction sheet concerning the operation of the
appliance when air is discharged from the room.
Warning: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards
When the range hood and appliance supplied with energy other than electricity are
simultaneously in operation, the negative pressure in the room must be not exceed 4 Pa
(4×10
-5
Bar)
Drill 3 x 8mm holes to accommodate the bracket. Screw and tighten the bracket onto
the wall with the screws & screw plugs provided.
Lift up the cooker hood and hang onto the wall bracket hook.
Fix the one-way-valve to the air outlet of the cooker hood. Then, attached the exhaust
pipe onto the one-way-valve as shown below.
Screw plug
Wall bracket
Screw
(4mm x 30mm)
Wall bracket
Cooker hood
Exhaust pipe
Cooker hood
Holes on wall