MAIN PCB PROGRAMING
3. FUNCTION MODE(Manual defrost, Error display, Model change. etc.)
3-1) Enter the Function mode
▶ Press the both up/down (or +/-) buttons at the same time for 5 seconds.
88 LED display "SL".
3-2) Manual Defrost Mode
▶ initiate the manual defrost function by pressing the down (-) button once
while displaying SL on the display. Then, the display will show ‘dS’.
▶ if the down (-) button is pressed again while displaying ‘dS’, it will display
‘dF’ and it is in manual defrost mode.
▶ Repeat the procedure to terminate the manual defrost
▶ Repeat the procedure to terminate the manual defrost.
3-3) Error display Mode
▶ Press the down (-) button 4 times while displaying ‘SL’ on the display.
If there is no error in the memory, display will show ‘no’.
Summary of Contents for TGIM-23*
