11
Turbo air
1. LOCATION -
Allow adequate space and install the refrigerator on a firm and level
floor. If the appliance is not level, there may be unusual noises and poor cooling
performance.
2. GOOD AIR CIRCULATION -
Be sure to avoid any partition and object which may
stop the air flow and that air space is allowed to flow to the rear and/or sides of the
unit between the refrigerator and the back wall. Insufficient space causes vibration
noise, inefficient refrigeration, damage to the refrigeration system, and the waste of
electricity. (Turbo Air recommends that the rear of the unit should be no less than 5
inches from the wall)
3. PLACE ON STRONG FLOOR -
Be sure that the floor on which the unit is to be
installed is strong enough to support the total weight of the cabinet and any other
contents, before starting the installation.
4. DO NOT PLACE NEAR HEAT -
Be sure to avoid hot corners and other locations
such as near stoves. High ambient temperature will result in much lower cooling
efficiency.
5. INDOOR USAGE ONLY -
Be sure to install this unit indoors only, to prevent getting
wet from the rain.
Do not install the refrigerator in locations where the temperature is over 100°F (38°C)
or below 50°F (10°C ).
6. STABILIZING -
Make sure the unit is installed in a stable condition with the front
wheels locked while in use.
7. LEVELING -
Be sure that the unit levels from the front to the back and side to side.
8. UNIT SHOULD BE ON DEDICATED OUTLET -
Plug the refrigerator into a wall
socket exclusively for this appliance. Do not run on extension cord.
9. THE ELECTRICAL PLUG MUST BE ACCESSIBLE WITHOUT MOVING THE UNIT.
10. WHEN POSITIONING FOOD FOR STORAGE, A MAXIMUM OF ONE SHELF MAY
BE LOADED LESS THAN 110
lb
(50
kg
), BUT DO NOT ALLOW LOADS TO
OVERHANG FROM THE FRONT AND REAR EDGES OF SHELVES.
INSTALLATION
Loss or spoilage of products in your refrigerator/freezer is not covered by warranty.
In addition to following recommended installation procedures, you must run the
refrigerator/ freezer 24 hours prior to usage.
NOTICE TO CUSTOMER
