Tunze 7096, Instructions For Use Manual

Page: 77 / 157

77
„Pulse only“ - wave simulation
The pulse operation produces biologically active current pulses (=waves); thus simulating the wash of
waves. The larger the difference is between the performances of the pumps set, the larger the wave
characteristic of the current.
Click the “Pulse only” button in the “Mode” field.
Click „Power 1“ and „Power 2“ pump outputs in the „Power control“ field to set channels 1 to 4. Figure
“0” indicates that the pump is not operational. The lowest possible setting is 30 per cent which can be
increased to 100 per cent.
Set the “Pulse flow” pulse frequency from 0.30 to 8.00 seconds. This pulse frequency is precise and can
also be used as Wavecontroller.
Up to four pumps can be connected directly. By using two branch adapters 7092.34, an extension to a
maximum of eight pumps is possible.
Settings in practice
Prior to the initial operation, please ensure a secure attachment of the pumps / Wavebox in the aquarium !
Position the pumps in the aquarium in such a way that the settings on the Multicontroller cannot cause any
water damage due to excessive currents !