page 10 of 14
page 11 of 14
TS-UG-AP-017-010
TS-UG-AP-017-010
Status warnings
Warnings/status lights on the base alarm unit
The base alarm unit has warning and status lights to clearly indicate the unit’s
current status. When functioning correctly your Liberty300 base alarm unit will
normally look like this:
How to respond to warnings
Display
Warning
What to do
AC power failure
Check the home unit is plugged
into a working electrical socket
The alarm unit has a low
battery
Check the home unit is plugged
into a working electrical socket
and the battery switch is turned
ON.
The alarm unit failed to send
a message.
Check the home unit has a
working landline/GSM connection
The cellular connection has
failed.
Check the Antenna/SIM card is
plugged in to the alarm unit.
The telephone line has failed. Check the home unit is plugged
into a working telephone socket.
or
Is on the Display and the RED
HELP Button is flashing- The
red button on the alarm unit
has been pressed.
Nothing, an alarm call has been
raised to the monitoring centre.
If the warnings persist please contact Tunstall Customer Service on 1800 603 377.
The ‘MAINS ON’ light
and the ‘CANCEL’
(green) button should
be on
Your pendant
Your pendant (personal radio trigger) is wirelessly connected to your Liberty300
home unit and enables you to generate a call for help from anywhere in your
home or garden. The pendant should be worn at all times and can be worn
around the neck or on the wrist using the attachments supplied. Your pendant
is water resistant (to IP67 standard) up to one metre for 30 minutes. It can be
worn in the shower however wearing it in the bath should be avoided where
possible.
The pendant has the below features:
NOTE:
ON activation, the pendant will send a notification message via the base alarm unit to the
monitoring centre when its battery is low.
LED on the pendant
When pressed, the LED on your pendant will light up red. This is to indicate
that the blue help button has been pressed. If the LED flashes green when
pressed this indicates that the pendant is out of range or not operating
correctly. If the LED flashes red when pressed, this indicates that the battery is
low and should be replaced
.
Up to 300m radio
range (typical)
Water resistant
Low Battery re-
porting*