15
I. GEAR END ASSEMBLY
1. Bolt the gear housing (60) loosely into both
frames (64 , 65).
2. When reassembling, apply grease to parts
such as thrust washers, o-rings, and seals.
Slide the thrust washer (37) onto the output
shaft (40-9). Next, install the output gear set
(40) into the gear housing (60). Push the
gear set into the housing until it stops against
the thrust washer (37).
Make sure to line up the gear
teeth in all three planet gears in
the output gear set with the gear
teeth in the housing.
3. Install the output sun gear (47) into the output
gear set (40).
4. Install the inner thrust washer (43) onto the
input gear set (41). Insert the input gear set
(41) into the gear housing making sure it is
against the output gear set (40) and engaged
with the output sun gear (47). Put the outer
thrust washer (43) in place and slide the input
shaft (39) all the way though the output shaft
(40-9). Let the input shaft protrude out on the
gear end so that all of the spline is showing.
Make sure the correct end of input shaft is
towards the gear end.
5. Put the cover on and secure it with eight
capscrews (21), being careful not to damage
the o-ring (59). Install the the Intelliguard™
sensor (39) into the outer cover (55), again
making sure not to damage the o-ring (36),
add loctite and secure it with three capscrews
(44).
Make sure the input shaft
engages the gear in
the Intelliguard™ correctly.
Summary of Contents for Rufnek Intelliguard 45
Page 9: ...9 CLUTCH INSPECTION ...
Page 23: ...23 VISCOSITY CHART ...