1
A
bout the Leg Press Station
Congratulations on your new purchase of the Leg Press Station.
We hope you are completely satisfied with this product and wish
you many years of enjoyment.
T
uff Stuff Equipment
Every Tuffstuff product has been built to precise quality
standards and has been carefully packaged to ensure that damage
will not occur during shipment. The
TuffStuff
Warranty and signature
indicating final inspection has been conducted by our line foreman,
is an expression of our confidence in the completeness, the
materials, and workmanship of this product.
W
arranty
SEE A COPY OF WARRANTY ON BACK PAGE
R
egistration Card
To avoid unnecessary delays in warranty service and to insure
that a permanent record of your purchase is on file with our factory,
be sure to complete the warranty registration card and send it to
TuffStuff Fitness Equipment today.
P
rior to the Assembly of the Leg Press Station
1. We advise you to consult your local Tuff Stuff retailer if you
should have a question or problem regarding the proper
assembly of this unit.
2. Neatly organize and identify all parts according to the Exploded
View Diagram on Fold-out Pg. 7 and the Parts List on Pg. 8.
T
ool Requirements
1. One 9/16” combination wrench
2. One ratchet
3. One 9/16” socket
4. One rubber mallet
5. Multi-purpose grease
6. Measuring tape
7. Utility knife
Introduction
S
pecifications
1. Maximum Wt. Capacity
- 200 Lbs.
2. Total Machine Weight
- 150 Lbs.
Hardware Measurement Diagram
Note:
Due to continuing product improvements, specifications and designs are subject to change
without notice.
FIG. 1
Attach a Pulley 4 1/2” Rd. (#78-Labeled D5) to the
Leg
Press Bottom Connector (#46)
pulley bracket using one Hex Head
Cap Screw 3/8-16 X 1 3/4 (#101), two Flat Washers SAE 3/8” (#94),
and one Nylon Insert Jam Lock Nut 3/8-16 (#123).
46
D5
FIG. 2
Using a rubber mallet, insert two Plastic End Caps 2 X 3
(#132) onto the tube-ends of the
Leg Press Main Frame (#47)
. Next,
attach the Rubber Bumper 3/8 X 2 1/2 (#153) to the tube-end of the
Leg Press Main Frame (#47)
using one Hex Head Cap Screw 3/8-16
X 1 1/2 (#100), and the Steel Bumper Washer 3/8” (#177).
Next, affix the
Leg Press Main Frame (#47)
to the
Leg Press Bottom
Connector (#46)
using two Hex Head Cap Screws 1/2-13 X 4 3/4
(#112), four Flat Washers SAE 1/2” (#93), and two Nylon Insert Lock
Nuts 1/2-13 (#124).
47
46
132
132
153
Leg Press Station
