FIG. 3
Next, affi x the
Fulcrum (#3)
to the bracket of the
Main
Frame (#1)
and secure it into place using one Hex Head Cap Screw
1/2-13 X 5 1/2 (#32), two Flat Washers SAE 1/2” (#24) and one Nylon
Insert Jam Lock Nut 1/2-13 (#39). Next, affi x the
Fulcrum w/Brackets
(#4)
to the bracket of the
Main Frame (#1)
, in the position as shown
above, and secure it into place using one Hex Head Cap Screw 1/2-13
X 5 1/2 (#32), two Flat Washers SAE 1/2” (#24) and one Nylon Insert
Jam Lock Nut 1/2-13 (#39).
FIG. 4
Attach the
Foot Plate Bracket (#5)
to, both, the
Fulcrum
(#3)
and the
Fulcrum w/Brackets (#4)
in the position shown above,
and secure it into place using two Hex Head Cap Screws 1/2-13 X 5
1/2 (#32), four Flat Washers SAE 1/2” (#24) and two Nylon Insert Jam
Lock Nuts 1/2-13 (#39).
FIG. 2
Insert a Pulley 3/8 X 4 1/2 (#15-Labeled G5) into the pulley
bracket of the
Stabilizer Support (#2)
and secure it into place using
one Hex Head Cap Screw 3/8-16 X 1 3/4 (#28) and one Split Lock
Washer 3/8” (#46). Next attach a Rubber Bumper 3/8 X 2 1/2 (#44) to
the
Main Frame (#1)
and secure it into place using one Hex Head Cap
Screw 3/8-16 X 1 1/2 (#26) and one Steel Bumper Washer 3/8” (#48).
40
1
40
2
G5
1
2
44
1
3
4
5
4
3
FIG. 1
Using a rubber mallet, insert two Plastic End Caps 2 X 3
(#40) onto the tube-ends of the
Main Frame (#1)
. Next, attach the
Stabilizer Support (#2)
to the
Main Frame (#1)
, in the position shown
above, and secure it into place using two Hex Head Cap Screws 1/2-
13 X 4 1/4 (#31), four Flat Washers SAE 1/2” (#24) and two Nylon
Insert Jam Lock Nuts 1/2-13 (#37).
Note
: Refer to the Exploded View Diagram on page 8 for
further clari
fi
cation of this assembly.
2
Assembly Instructions
AP-2LPS_AP-2LPD Leg Press Option