Plus Sweeping Machine
III-4
Plus Sweeping Machine
III-5
3.3.1 Fork arm receptacle
The safety notices of Chapter 3.3 apply
Check fork arm receptacle and
fork arms for soiling and clean if
necessary.
The distance between the fork arms
must be adjusted on the carrier
vehicle before they are driven into
the receptacles!
• On both sides of the fork arm receptacle, pull
the knob (1) towards the protection bracket (2)
and tilt it upwards until it snaps into the groove
(3). The locking bracket (4) now points towards
the ground.
• Drive the fork arms fully into the receptacle.
• Move the locking brackets (4) back into a
horizontal position.
• Adjust the distance (A) to the width of the fork
arms.
• Unscrew the screw (5) on both sides. Shift the
locking brackets (4) to the appropriate width.
Reinsert the screw through one of the holes (6)
from the underside and tighten it.
• In addition, the fork arm receptacle must be
secured with a chain (9).
• The chain must be pulled tightly through the
loop (7) and the slide carriage (8) of the carrier
vehicle and must be secured with the spring
hook (10).
The chain (9) must not touch the
guide rails of the lifting gear.
Check for the correct locking of the
locking bracket behind the fork arms.
Ensure a tight fit of the chain (9).
• Connect the hydraulic lines according to the
instructions of the vehicle manufacturer.
• Connect the electric connection cable for the
water spraying device or illumination devices to
the cabinet in the carrier vehicle.
• Lift the sweeping machine and carry out a
functionality check.
10
N O T E
ATTENTION
ATTENTION
ATTENTION
7
Summary of Contents for Plus P1 HD 560
