SHERPA 2272/173 to 2272/177 operating instructions
61029_315_ind_
00
of
11/2013
http://www.tubesca-comabi.com/
PAGE
2/2
2.2.
Access
2.3.
Moving
2.4
Work positions
Moving when unfolded
Moving when folded
2.5.
Closing
Fold the unit up in reverse order to setting it up.
3.
Recommendations for use:
+ Do not use the platform without its guardrails, nor behind any door that has not been locked.
+ The platform must only be used on horizontal, non-slip surfaces.
+ All the platform’s feet must be in contact with the floor or ground.
+ On soft ground, a support plate must be placed under every foot.
+ Make sure that the work area is away from any bare conductor under load.
+ The platform must not be thrown or handled brutally when in use.
+ Always face the platform when climbing or coming down from it.
+ Make sure that you are wearing shoes that give you a firm footing.
+ Do not climb up the ladder if you suffer from vertigo or are tired.
+ Do not use the ladder without putting the stabilizers in place
4.
Maintenance:
+ Systematically check that the platform is in a good general condition before use (condition of parts and their
geometry. Should parts need to be replaced only use TUBESCA-COMABI components, see constructor after-
sales service instructions)
+ After use on a site, wipe the ladder with a clean cloth.
+ The ladder must be regularly checked and results of the check must be recorded.
HOLDER.
Open the gate to reach the work-floor. Once you are in position, the gate must be closed for working under correct conditions.
CLIP THE GATE INTO ITS
