Tubeline Boss I, Operator'S Manual

Page: 11 / 28

11
PROCESSOR OPERATION
SAFETY FIRST!! READ AND UNDERSTAND THE SAFETY
INSTRUCTIONS (
pages 3-6 of this manual)
BEFORE BEGINNING ANY
PROCESSOR OPERATION.
DANGER
Failure to obey the following procedure will result in death
or serious injury. Avoid contacting overhead wires.
WARNING
Failure to obey the following procedures could result in
death or serious injury.
Never lift this product: above the operator’s eye level OR
to a height where visibility is obstructed,
whichever is lower.
Use caution when raising loaded processor. Objects
could fall from processor toward bystanders or operator.
Remove all foreign objects from bales.
NOTICE
Refer to your power unit’s operator’s manual for safe
operating limit and use of counterweights .
To Load:
Load one bale at a time. If bales are frozen, put frozen side down to the table for better operation.
Center the bale on the forks before loading on to the table. Slide forks lightly on the ground when
loading bales. Store bales on level ground and on a clean surface free from rocks and other foreign
objects.
- Adjust discharge deflector to spread forage at desired width.
- Operating power unit at maximum R.P.M. allows the processor to do a better job of chopping forage.
- Twine build - up should be kept to a minimum to reduce fire hazard and keep the machine in balance.
- Always lower the processor to the ground; set the parking brake; stop the engine; remove ignition key
and wait for all moving parts to stop before leaving the operator’s seat.