TubeDepot Tweed 5F1, Assembly Manual

Page: 7 / 39

It is important to review all the parts that came with your kit. The list below is what you
should have received to complete your kit. If you find anything missing, contact us:
Qty Description Application
1 speaker, 8" Jensen MOD,
8 Ω (4 Ω available)
speaker
1 chassis, steel chrome plated 5E1/5F1 chassis
1 cabinet, tweed 5E1/5F1 cabinet
1 PCB board, 5E1/5F1 _ printed circuit board
transformers
1 transformer, ClassicTone 40-18027 power transformer
1 transformer, output tweed 5F1 4 & 8 ohm tap output transformer
tubes
1 5Y3 rectifier tube rectifier tube
1 6V6GT beam power tetrode power tube
1 12AX7 dual triode _ preamp tube
panel hardware
1 knob, vintage pointer knob
1 fuse holder, conical cap, vintage Fender style fuse holder
1 fuse, 3AG 2A slow-blow fuse
1 lamp holder lamp holder
1 jewel, red lamp jewel
1 lamp, #47, 6.3 V lamp
2 jack, 12A, shorting, Switchcraft ¼" input jack
1 jack, 11A, open, Switchcraft ¼" speaker jack
3 washer, lock 3/8" jack lock washer
1 plug, Switchcraft ¼" speaker plug
power cord hardware
1 power cord, grounded three prong, 12' power cord
1 strain relief, Heyco power cord strain relief
1 nylon cable clamp power cord clamp
1 screw, zinc plated #8 x 5/8", phillips flat head cord clamp mounting
tube sockets
1 socket, tube, miniature 9pin preamp tube
2 socket, tube, octal rectifier / power tube
hardware
2 grommets, rubber 3/8" hole grommets
2 bolt, 1 1/2" 10x32 truss screw chassis mounting
2 nuts, KEPS 10x32 chassis mounting
6 screw, zinc plated 6-32 x 1/4", phillips pan head tube socket mounting
9 nuts, KEPS 6x32 tube socket / PCB mounting
1 nuts, 6x32 tube socket w/ solder tab mounting
4 nuts, KEPS 8x32 power / output transformer mounting
2 nuts, 8x32 power transformer w/ solder tab mounting
4 screw, zinc plated 6-32 x 7/8" phillips pan head PCB mounting
4 standoff, nylon; L = .5"; id = .140"; od = .250" PCB mounting
2 screw, zinc plated 8-32 x 1/4", phillips pan head output transformer mounting
2 solder lug, locking, #8 screw grounding at power transformer
1 solder lug, locking, #6 screw grounding at preamp tube socket
1 wire nut power cord to power transformer wiring
electronic, resistors
2 100, 1/2w carbon film filament pseudo center tap
2 68K, 1/2w carbon film input resistors
1 1M, 1/2w carbon film _ input biasing resistor
2 100K, 1/2w carbon film preamp tube plate resistors
TubeDepot.com 3
Parts Inventory
3
TubeDepot.com
1958 Vanderhorn
Dr.
Memphis, TN 38134
(877) 289-7994
info@tubedepot.com