TubeDepot JTM45+, Assembly Manual

Page: 15 / 45

Installing the Grommets
Step 1 – install 1/2” grommets in the appropriate holes on the
top of chassis (photo 5.3a).
Installing the Tube Sockets
Step 1 – Modify the tube shield covers by flattening both ends
of the base so that the mounting screws will properly lay flush
against the chassis (photos 5.4a and 5.4b).
Step 2 - Install the three 9 pin tube sockets in the appropriate
holes in the chassis. Note alignment of sockets and which #6
screws are used (drawing 5.4a).
Step 3 – Install the three octal
tube sockets in the appropriate
holes in the chassis. Make sure
to include the #6 solder
terminals on the power tube
sockets. Note alignment of
sockets and which #6 screws
and nuts are used with each
socket (drawing 5.4b).
TubeDepot.com 11
drawing 5.2a
5.4
photo 5.4a
flatten here
photo 5.4b
5.3
photo 5.3a