Tube-Line TL1700SR, Operator'S Manual

Page: 21 / 55

4-2
Section 4: Adjustments and Repairs -
TL1700SR
Fig.3.3
Tensioner Adjustment
Adjust tensioner up or down by turning roller on
bottom of tensioner mount arm (
Fig.3.3 ), wrap
should be applied across the mid section of the bale.
Knife Adjustment
The plastic knife on the end of one of the rollers is used to cut the plastic after the bale has been wrapped. It
can be raised or lowered to match where the plastic falls depending on bale size/type.
In general, round bales need the knife raised higher than round bales.
Avoid damaging knife by checking tensioner clearance BEFORE operating turntable at full speed.
To adjust knife see Fig.3.4 :
• Turn handle to loosen.
• Push handle up or down to adjust accordingly.
• Tighten handle to lock knife to desired height.
Fig.3.4