2531DM-0022
9
1.
Turn on incoming water supply. Ensure that you have adequate water
pressure between 1.0-5.5 bar.
2. Turn your showerhead to its “off” position.
3. Turn the gas valve on the cylinder all the way open.
4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE GAS VALVE IMMEDIATELY!!
5. Set the water regulator knob on the face of the portable tankless water heater to
its highest setting.
6. Set the gas regulator knob on the face of the portable tankless water heater
to its minimum setting.
(Switch on the “on- off-button on the bottom of the device”)
7. Turn on your showerhead to the “on” position and adjust to the desired water flow.
8. There will be a series of audible clicks and the burner will ignite. Should the burner
not ignite after 5 seconds, shut off and go to the “Trouble Shooting” section.
9. The temperature of the outgoing water is dependent on the temperature of the
incoming water balanced with the amount of heat applied. Use extreme caution in
setting the outlet water temperature.
Adjustment
Warning:
THE PORTABLE TANKLESS WATER HEATER IS CAPABLE OF PRODUCING
SCALDING WATER TEMPERATURES!
10. With the water regulator set to high, and the gas regulator set to low, feel the
outgoing water. This is the lowest setting available.
11. To initially raise the outgoing temperature, slowly turn the gas valve towards
maximum. Adjust slowly and check the temperature often. There will be a slight
delay between increasing the gas supply and the increase in water temperature.
12. Should the outlet water temperature need to be higher, slowly reduce the water
flow regulator until desired temperature is reached.
(Warning: Do not alter or change this water heater’s original temperature sensor)
13. Upon completion of use or storage, open the drain valve (ribbed cylindrical stem
next to the water input valve) to ensure draining of water.
14. Turn off your gas supply.
If the water heater is stored for a longer period, please remove the batteries from the
battery compartment and drain the water heater from all its water.
Warning:
lf the outside temperature is around or below freezing, ensure that the drain valve is
opened and water drained trom the portable tankless water heater after each use
to avoid internal damage to the water regulator. You will also need to unhook the
outgoing water line to ensure that any water in the heat exchanger is drained. Failure
to properly drain your portable tankless water heater will cause frost damage which
may or may not be reparable and is not covered by warranty.
Summary of Contents for Outdoor HD-6
Page 13: ...2531DM 0022 13 ...
Page 17: ...2531DM 0022 19 9 Declaration of conformity ...
Page 22: ...12 Notes 24 ...
Page 23: ...2531DM 0022 25 ...
