TTi’s
PantherPatrol
™
HandBook
6
Call 1800 816 277
www.tti.com.au
6
Start Up Procedure
Prepare the engine for start up as per the engine manual and pump manual.
Add the spray solution to the tank (See “Mixing and Filling”).
Ensure that the pressure regulator lever is in the ‘open’ position and the pressure
adjusting knob is screwed out (anti-clockwise). Failure to do so will invalidate pump
warranty.
Start the engine and allow it to warm up. Run the pump with the regulator lever
in the BY PASS position in order to discharge entrapped air from the system for at
least two minutes before changing the regulator to the closed position. (Rotate
clockwise)
To set the correct spraying pressure, open the flow through the hand gun (discharge
solution back to tank) and turn the pressure regulator knob in a clockwise direction
until the required pressure is achieved. Spray nozzle pressure will vary according to
hose length, nozzle size, etc. When the hand gun is released the increased pressure
in the system will be automatically adjusted by the pressure regulator valve and
excess flow will be returned to the spray tank.
Maintenance
After use the sprayer must be thoroughly decontaminated, inside and out, to
prevent damage to the unit from corrosion or abrasion.
When storing the unit ensure that it is clean and dry and store in a well ventilated
place.
If operating in areas where freezing occurs we recommend leaving anti-freeze in
the pump, regulator and handgun while not being used to prevent possibility of
frost damage.
