Agriculture Drone T1 User Manual
13
2018 TTF All Rights Reserved
1 Mode
Indicates current flight modes
8 Flight Route Plan Interface
For users to plan the flight route.
2 Voltage
Indicates the current voltage of battery, to check if there is sufficient charge.
9 Flight Data
Flight Speed, Spray Flow, Flight altitude, Flight Distance
3 GPS Satellites QTY
Indicates the QTY of the GPS Satellites, to check if the aircraft can fly normally.
10 Location Follow
Tap to center the map around the aircraft’s location or my location at all times,
following its location update.
4 Status Information
Indicates the self-test status of flight control and abnormal information, such
as vibration, voltage alarm.
11 Flight Route Plan
Tap to enter Flight route plan interface.
5 Remote Controller Signal
Shows the signal strength of the remote controller.
12 Return to Home
6 Signal Strength of Data Transmission
Indicates the connection status of data transmission, RTK etc.
13 Take-off / Landing
Click to landing when aircraft in sky. Click to take-off when aircraft on ground
7 Parameters Setting
Consist of general parameters setting and advanced parameter setting. General setting is applied for terminal customers to adjust some basic parameters.
Advanced setting is for UAV manufacturer. (Terminal Customer should NOT change the advanced setting information.)
Speed and sparying range setting under AB points Mode
Click the parameter setting on top-right corner, then enter setting items.
1.
Read the data.
2.
Spraying range and speed setting (Suggested spraying range is 4m, flight speed should be 6m/s when flow is 1.4L/min,
flight speed should be 8m/s when flow is 2L/min.) Under this data setting, 1L Liquid can be used for 666
㎡
.
3.
Save the data
Note: DO NOT modify other parameters, TTF assumes no liability for improper modification.
How to set the broadcast and cell phone vibration function
