Introduction
Please read the full user guide
available on the website
before bringing this device
into service.
This symbol on the device
or the package means
that all electronic and
electric equipment should
not be mixed with general
household waste.
Visit
www.s-2connect.com/
documentation
Installation
1. Make sure there is no damage to the
equipment.
2. Choose your suitable installation location.
Consider the environmental requirements
and be advised that this device contains
antennas that could be affected from other
equipment within close range.
3. Remove the battery isolation tab. See below
for instructions.
4. Check the LEDs to verify proper operation.
1. Use the battery hatch
key provided to open or
close the battery hatch.
2. To activate the battery,
lift the battery hatch
and remove the battery
isolation tab.
3. When replacing the
battery, pay attention to the
plus and minus indicators.
4. Close the battery hatch
carefully using the battery
hatch key. Ensure the hatch
is aligned with the indicator
as shown.
Activating and replacing the battery
Switching the
device on
This device switches on
automatically following insertion
of the battery.
Using the device
This device is intended for strictly
remote operation. Log in to your user
interface to interact with the device.
LED functionality
The LED in S-2CONNECT Sense
operates as follows:
• Long Blink at battery insertion
• Short Blink when communicating
with S-2CONNECT Hub
Radio frequencies
Radio technology
Bluetooth
Frequency band
2.4 GHz BLE
S-2CONNECT
S-2CONNECT Sense must
be used in compliance
with applicable and
international regulations
that restrict utilisation
of radio communication
modules. Refer to the full
S-2CONNECT Sense user
guide for more information.
The full user guide can
be downloaded from
www.s-2connect.com/
documentation
Declaration of Conformity
TT Electronics hereby declares that S-2CONNECT Sense complies
with the essential requirements of the EU directive RED2014/53/EU
Full details available at:
www.s-2connect.com/documentation
FCC Compliance
S-2CONNECT Sense has been tested to fulfil FCC requirements. Test
reports are available upon request.
14
15
