7/10
5.
Tightening method for adjustable bolts
Make sure Spirolox is surely in the ditch.
The Pilot plate for TL10 have 8 pcs. of adjustable bolts,
for TL14 and TL20 have 5 pcs. adjustable bolts.
Place the Spring plate and Disc spring in contact
with each other, and tighten the Adjustable bolts
manually until there is no backlash between their faces.
At this time, the center of the Adjustable bolt, Spring
plate, and the Disc spring must become the same.
Afterwards, retighten the adjustable bolts to the appropriate angle.
After completing the torque setting, thread the wire through the hole of the adjustable bolts,
and fix the wire firmly.
6.
Replace the friction facing
Change the friction facing when they reach roughly half the thickness of dimension
described in the catalog. 2mm for TL10
～
TL20.
Before replacing the friction facing, each part must be completely free of oil, rust and dirt.
Also, reassemble the Torque Limiter according to the structure drawing.
7.
Maintenance and precautions after the replacement procedure
Periodically inspect the torque setting, for the initial torque setting may be affected by
changes in friction, ambient temperature, humidity and other conditions.
Replace the friction facing and bushing if they wear. Their replacement parts are in stock.
Keep the Torque Limiter free from water and oil. This will maintain the effectiveness of
torque and prevent the equipment or load from falling, and causing serious accidents.
8.
Torque Limiter Coupling
Refer to the heading 1
～
heading 7 for assembly of Torque Limiter, torque setting and
precaution.
Summary of Contents for TL10-C
Page 6: ...6 10...
