buyTSI.com - 800.223.4540
1.
Thoroughly read all of this manual before using this machine.
2.
Only personnel trained should operate this machine.
3.
Personal Protective Equipment must be used including safety glasses.
4.
Never wet the motor, electric switch, or components. Cover these items if machine is to be
washed. Always disconnect electrical power before attempting any maintenance.
5.
Remove all debris from tires before using the grooving tool
Safety Requirements
Installation Requirements
Set-Up Instruction
1.
Uncrate machine and remove all packaging materials.
2.
Insert upper control arm support tube into lower tube socket and tighten locking cap screws.
3.
Insert cross arm over vertical arm support – adjust to upper vertical height. Tighten lock nut.
4.
Insert base level screws and level machine.
5.
Remove solid reservoir plug in rear of machine and replace with reservoir breather.
6.
Connect electric cord to electric supply.
7.
Connect airline to air valve at rear of machine.
8.
Insert grooving cutter into grooving head. Depending on width of groove desired, a variety of
cutters are available. Choose width as desired.
9.
After grooving cutter is installed – tighten locking screws to retain grooving cutter.
10.
Grease zerks that are marked to grease on a regular basis. Apply light oil to all other moving
or pivot points.
115 Volt, 60 Cycle, 20 Amp and 90 PSIG Air x .25” diameter air hose
220 Volt, 50 Cycle, 20 Amp and 90 PSIG Air x .25” diameter air hose
