buyTSI.com - 800.223.4540
Operating Instruction (continued)
1.
Operating control levers -
The left lever controls the shear arm. The center lever controls the
tire push/pull bars. The right lever controls the tire lift.
2.
Insert the hydraulic push/pull bars into their sockets.
Adjust length as required for tire width, either by the
ball detent pin or with the adjusting cap screw.
3.
Position stop arms on the lift as required.
4.
Insert ball detent pin into stop arm pin holes.
Truck Tire Cutting Instruction
1.
With arms positioned as shown, roll tire on hydraulic tire lift pad.
2.
Start engine by following engine operating instructions.
3.
By operating tire lift control lever on the right, the tire is raised to the
cutting table.
4.
Tip tire up and over to positioned in the center of the cutting table.
5.
Using center hydraulic control lever, move tire push/pull bars firmly
against the tire. By operating the lever on the left, move shear arm
down to begin the shearing process.
6.
Continue to shear tire all the way through. Some additional adjustment may be done to the
push/pull bars during the shearing to maintain pressure or position on the tire.
7.
NOTE: Tire debris may be deposited below the cutting table during normal shearing
operation. Before the next tire is placed onto the cutting table, ensure all of the cut debris is
removed from machine.
8.
Reposition the push/pull bars after the shear blade returns to the up position. Then
reposition both of the tire halves and shear through them both.
9.
Complete shearing the tire halves. When completed return the shear blade to the up position
and the push/pull bars rearward to the start position. Remove the cut pieces from the cutting
table.
