-7-
Reviewing Data
1. Use the
Data
screen to review data that has been
collected. Use the scroll bar (slide) on the right to
scroll though the records.
2. The record number is displayed near the bottom of
the screen. As each record is selected, its data and
relevant parameters are displayed.
3. Descriptions of each section of the data display
screen are given in the following table.
Data Screen Labels and Controls
Field
Description
#, ft
3
, m
3
Button used to change between counts and
concentration displays.
Size
Channel size.
Differential concentration.
Cumulative concentration.
Export the data to a flash drive.
Print data to the optional printer.
Zone (Z)
Zone in which the data was collected.
Location (L)
Location within the Zone.
Date
Date on which the data was collected.
Time
Time at which data collection was initiated.
Sample
Duration of the sampling period.
Vol
Volume of air that was sampled.
Alarm
Alarm threshold was triggered (Yes) or not
(No).
Inst
Status of the instrument hardware.
OK
if no
issues or an error abbreviation if instrument
has a possible issue.
Temp
Temperature at the end of the time the data
was collected (if optional probe was
connected during sampling).
Data Screen Labels and Controls
Field
Description
RH
Humidity level at the end of the time the data
was collected (if optional probe was
connected during sampling).
Vel
Velocity of the ambient air at the sampling
location as measured by a connected TSI
Velocity probe (optional).
Record
The record number of the sample being
displayed.
Records
Total number of records.
Instrument Configuration
Select the
Setup
tab page and tap the
Device
button to
get to the Device Setup page from which you can
access screens that allow you to set or change the date
and time, calibrate the touchscreen display, set up
communications, make regional selections, or get to the
Service screen.