TSI Instruments 854033, Quick Start Manual

Page: 2 / 4

-2-
This guide will help you quickly install the Enclosure
Heater (854033) for the Environmental Enclosure
(854030).
Unpacking
1. Unpack the enclosure heater and verify that all the
items listed in the following table are present.
2. Contact TSI immediately if items are missing or
broken.
Qty. Item Description Reference Picture
1 Power Supply,
300 watts
1 Thermostat
1 Power Connector
www.phoenixcontact.com
Feed-through terminal
block. Gray.
Small,
P/N 3040012.
1 Ground Connector
www.phoenixcontact.com
Spring cage ground
terminal block. Green
Small P/N 3040025
Qty. Item Description Reference Picture
1 Heater
2 Vent Plugs
Warning Labels
Warns that the instrument could be hot to the
touch or a burn hazard.
Installing the Enclosure Heater
(854033)
1. If Model 854034 power supply is installed, unplug
the DC power cable from DIN rail, unplug the main
power to the power supply, and snap the power
supply clip off the upper DIN rail and go to step 3.
2. If not already installed, add top DIN Rail Mount:
Remove nuts from welded stud and mount DIN Rail
Mount to Weld Stud. Install the upper DIN Rail onto
the mounting brackets using the provided #10
hardware. Mount the DIN Rail w/Mounting Brackets
to the Enclosure Weld Studs using the Kep Nuts
provided with the enclosure.