TSC TTP-243 Plus Series, User Manual

Page: 34 / 39

32
4.1.3 Printer Initialization
Printer initialization clears all downloaded files resident in flash memory, and sets
printer parameters to default values.
Parameter Default Value
Speed 200 dpi: 50.8 mm/sec (2 ips)
300 dpi: 38.1 mm/sec (1.5 ips)
Density 8
Label Width 4"(101.6 mm)
Label Height 4"(101.6 mm)
Sensor Type Gap sensor
Gap Setting
0.12” (3.0 mm)
Print Direction 0
Reference Point 0,0 (upper left corner)
Offset 0
Tear Mode On
Peel off Mode Off
Cutter Mode Off
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory Yes
Please follow the steps below to initialize the printer:
1. Turn off the printer power.
2. Hold down the PAUSE and FEED buttons and turn on the printer power.
3. Do not release the buttons until the three LEDs flash in turn.
Note 1: Printing method (thermal transfer or thermal direct printing) will be
set automatically at the activation of printer power.
Note 2: When printer initialization is done, please calibrate the gap sensor
again.
Note 3: Download files will be deleted after printer initialization.