Tryton TMM10034, Operating Instruction

Page: 7 / 48

7
drilling in this mode. The hammer drill works with jerks or sparks are visible:
ź
Horizontal position of drilling can be controlled using the spirit level - check and replace carbon brushes.
( 7 ).
NOTE! Carbon brushes can be replaced only by competent electricians.
ź
When drilling in concrete, stone or walls hard alloy drill bits should be - If the power tool does not work despite being supplied from a proper
used.
power source, have the tool repaired sending it to the service center
located at the
w arranty card
ź
When drilling in metal use sharp metal drill bits only.
NOTE:
STORAGE AND MAINTENANCE:
Generally, this power tool does not require any special maintenance.
Store the machine in a place away from children, keep it clean and
protect from humidity and dust. Storage conditions should exclude any
mechanical damage and weathering.
External plastic parts of the machine can be cleaned with use of a wet
cloth and a mild cleaning agent.
NOTE: NEVER use any solvent-based cleaning agents.
After drilling in concrete, in intensely dusty environments it is
recommended to remove dust from ventilation openings and the drill
chuck with a stream of compressed air. It will protect bearings and
remove the dust obstructing motor cooling air supply.
TRANSPORTATION:
The hammer drill should be transported and stored in its transportation
case that protects the tool from moisture, penetration of dust and fine
particles. In particular it is necessary to protect the ventilation openings.
Small objects that get into the device can damage the motor.
TROUBLESHOOTING GUIDE (TYPICAL PROBLEMS):
The hammer drill fails to work:
- check whether the power cord is properly connected and check fuses.
address specified in .
n
Overload safety coupling
MANUFACTURER:
When the running tool is seized or jammed, the driving torque is no
PROFIX Ltd.,
longer transmitted to the spindle of the hammer drill. Due to excessive
34 Marywilska Street,
forces and torques occurring when the machine is running operators
03-228 Warsaw, POLAND.
should always reliably held the machine with two hands and take a
PROTECTION OF THE ENVIRONMENT:
steady position of the body.
The symbol nearby denotes that old equipment must
When the running tool is seized, it is necessary to switch the machine off
never be thrown away together with other waste (with the
and release the tool. Be careful as switching the seized machine on leads
penalty of a fine). Hazardous components of electronic
to strong and rapid reaction torques.
equipment may adversely affect the natural environment and
human health.
Each household may contribute to the recovery and reuse (recycling) of
old machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
machinery and appliances. Moreover, general purpose collecting points
for such equipment are available.
PICTOGRAMS:
Explanation of the icons located on the nominal plate and the
information tags
.
«Always wear safety goggles»
«Wear » hearing protection
«Wear a dust mask»
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device
purchased.