Trynex International SnowEx V-Maxx 8500, Manual

Page: 27 / 36

© Trynex International 2006 L1159
4 — 27
Operating the Spreader
(continued)
BAFFLE INSTRUCTIONS
• The V-Maxx 8500 uses a dual baffle design over the auger area.
This baffle (D6809) is used for dry bulk materials. The baffle is
designed to reduce the risk of leakage with clean/dry free-flowing
materials. If the material you are using is damp/wet, you may need
to remove baffle (D6809). This will allow for more un-restricted flow
of materials and possible bridging.
• WARNING: Always disconnect power source before attempting to
remove material baffle.
• The main baffle assembly (D 6808) MUST never be removed from
its original factory installed position unless the unit is being serviced
or installing Optiflow Kit.
BAFFLE EXTENSION INSTRUCTIONS
• The Baffle Extension is installed at the time of assembly. The main
purpose of this baffle is to keep dry, free-flowing material from
leaking out.
• If you plan on using damp/wet materials, you should remove this
baffle by removing the self-drilling screws.
• If you are using a sand/salt mixture, remove baffle extension.
D6809
Key Part No. Description Qty.

D 6847 Salt Baffle Extension 1

D 6807 Discharge Baffle 1

D 6874 #14 x 1-1/2" TEK w/Neo Washer 2


