Sensor
18
© 2011 TRW Automotive, Parts & Service
Step 5.
Pull sensor bottom cover out (fig.3.2.5), match it with the upper cover cap and tighten it with the
spanner wrench. (fig.3.2.6)
Step 6.
Sensor Anti-theft Function Test
Use fingers to spin the sensor body anti-clockwise to check if the sensor is spinning freely and can not
be removed by turning. (fig.3.2.7)
Step 7.
Repeat steps 1-6 for other sensors.(fig.3.2.8)
Step 8.
Verify if the sensor works properly.
The LCD Display Monitor should indicate the tyre status within 1 minute after installation.
fig.3.2.5
fig.3.2.6
fig.3.2.7
fig.3.2.8
Note:
If there is no tyre information displayed after 15 minutes, please check the sensor’s battery
status, replace and reinstall the battery. Refer to “Troubleshooting” section on how to change a sensor’s
battery.
Note:
If this is a replacement sensor please write with waterproof marker the correct sensor name on the
blank sensor label (i.e. 1R, 3L) according to tyre diagram (fig. 20)
Summary of Contents for EnTire Solution TPMS
Page 1: ......
