Maintenance
Warning: Always make sure the Edger is completely disabled by making
sure the engine has stopped and removing the spark plug lead before you
remove any guards or do any maintenance.
Adjusting the Drive Belt
Changing the Blade
WARNING: Make sure the spark plug lead has
been disconnected.
Put a Stiltson on the pulley
in the inside of the blade guard. Undo the bolt
on the end of the drive shaft. It is best to use a
air gun to remove this. Be careful the blade
might rotate while loosening or tightening.
WARNING: Make sure the spark plug lead
has been disconnected.
Undo the two bolts
on the blade flange. Pull the cutting head
out so the belt is tight. Redo the bolts up.
Do not over tighten drive belt
